Gaggia Classic Manometer/Gauge and Dimmer Housing

This housing contains the following components needed to upgrade the Gaggia Classic/Pro. Also it will work with other machines e.g. Rancillio Silvia etc.

1. 40mm Pressure gauge
2. Pump dimmer

There are three 3d parts:

1. The cylindric housing
2. The holder without angle for attaching it flat.
2. The holder with a 20° angle for better readability of the Gauge.

The Holder/s have space for two magnets (12 x 3 mm). I found out that this diameter is strong enaough to hold the housing in place without sliding as you use the Dimmer. You have to print one of the holder and superglue it to the housing. Or just put it in your design-software and combine housing and holder and print it as one part. I Printed it in PETG but as there is no temprature issue you can print it as well in PLA etc.