Roost Cafe Coasters - Animal Crossing

A coaster set featuring Brewster's logo from Animal Crossing Roost Cafe. The embossed version is one file and straight forward to print. The multicolor version is designed to print with Z Hop enabled.  If you want to slice your own multicolor, here are the steps:

1. Set Cura to your filament color for the cup (red), a layer height of 0.2 mm, and skirt turned off
2. Load the cup, brewster, and coaster models
3. Select all models
4. Edit > Merge models (this will snap them into the correct orientation)
5. Move the merged models somewhere where they will not interrupt your bed-leveling or homing routine
6. Unmerge models
7. Delete the brewster and coaster models, slice cup as normal.
8. CTRL+Z to get the other two models back, and set your Z-hop height to 0.4 mm or higher
9. Delete the cup and the coaster models, set your filament color to brewster (green), slice brewster with the Z-hop enabled
10. CTRL+Z to get the other two models back, delete the cup and brewster, set your filament color to the coaster (white) and slice with Z-hop still enabled
11. Print the cup gcode, immediately followed by the brewster gcode, immediately followed by the coaster gcode.

If you want to use my pre-sliced gcode, please note it was sliced for an Ender 3 V2 with UBL 3 point tilt enabled.