about the remix:
added a few simple drain holes and lowered the overall height
Printing:
print with 0.2 layer height and with PETG. both is better for easier cleaning later.
Note from me:
You can lower down the model a bit under the built plate in your slicer to save printing time.."drop model to plate" -> "off" in cura (3 bottom layers for the tooth paste base plate is enough)
Note from the remix of international_man_of_mystery:
"Made the center 10% wider to better accomodate toothpaste tube.
Made the right side the same as left without the holes for extra heads."
https://www.thingiverse.com/thing:5024544
https://www.printables.com/model/157613-oral-b-tooth-brush-holder-station-remix
Original design by Motoarzan :
https://www.thingiverse.com/thing:2283814
The author remixed this model.
added a few simple drain holes and lowered the overall height