Stealthburner Clockwork 2 HALL Filament sensor

Based on the the ideas of @DavidRelich and Voron Afterburner hall effect filament sensor,
i'll give you the hall sensor mod for the stealthburner clockwork 2.

INFO: the photos show the old model! The print files are the updated version, fitting the vorondesign parts updated in July 2023.

For this mod you will need:

• up to 2x AH3364Q-P-B (working at 3V up to 24VDC so you can connect them to standard endstop connectors on your mainboard)
• up to 6x 4x1mm Neodym magnets (i stacked 3x magnets for each sensor) 
  • alternativ you can use each 4x3mm magnets
• up to 2x 3x7x0.5mm steel shims (must be magnetic! Can be found in Voron 0 kits.)
• 
   

FYI: a hall effect sensor works with magnetic field -  just a little spacer is pushed away by the filament to activate the sensor. That means much less friction in the extruder path and nearly no wear with the involved components (compared to ball activated micro switch, where the little knob of the microswitch will be slowly scraped over time)

There a 3 Versions available:

1. Standard
   only 1x Sensor above the driving gears
    
2. Dual
   two Sensor can be installed simultaneous.
   1x above and
   1x underneath the driving gears.
   The idea is to have a filament runout sensor for normal use, and another for MMU mods like the ERCF (which needs or needed the sensor underneath the driving gears
    
3. ERCF only
   as the name describes, this variant is for only MMU mods, where one single sensor has to be after the filament driving gears.

As always you will find .STL and PRINT.STP for direct use in your slicer,
and ASSEMBLED.STP to modify in your CAD program. 

Do not slice any ASSEMLED.STP - this files contains ECAS, steel balls and the hall sensors! 
They are only attached for modifications with CAD  programs!

modified the original ‘main_body’