Gridfinity 1x2 Low Riser Angled Base Extenders

These are 1x2 gridfinity modules.  Their function is to be an angled baseplate.  They are low, but they will still raise up any module on them as well as angling them forward.  There are versions with angles in 5º increments up to 20º.   This lets gravity collect things on one side of a module, or makes it easier to look inside, or access tools, etc.  

If you reslice these, I recommend:

• A 5mm brim with a 0mm brim separation gap.  This helps prevent the edges from lifting upward. 
• External perimeters first
• Infill 10% gyroid
• Only one layer of skirt - additional layers don't do anything useful that I can tell.

This is one of three angle baseplate models.  The other two are:

• Glue-on 1x2 Angled Gridfinity Baseplates
• Gridfinity 1x2 Tall Risers

Based on the Gridfinity System from Zack Freedman: https://thangs.com/designer/ZackFreedman 

https://www.youtube.com/c/ZackFreedman

License: CC BY-NC-SA 4.0 https://creativecommons.org/licenses/by-nc-sa/4.0/
 

#gridfinity