Voron V0.2 - Tophat 1515 sealing block

During my attempts to increase the chamber temperature, i noticed that there were small gaps all over the tophat, allowing warm air to escape.

To reduce this I have designed a small block onto which 8mm wide self-adhesive foam strips can be glued. The block is slightly beveled, which makes it easier to close the tophat and also provides a good sealing.

There are 2 versions : 

• Large one (single one to print for each side)
  • Use 4x M3x8mm screws to fix it in place
• Small one (print 2x parts for each side - printable on V0 itself!)
  • Use 8x M3x8mm screws to fix it in place

For reference - these are the foam stripes I used. 8mm wide and ~1mm thick (leftover from Formbot kit), just glue them into the groove on the side :