LTC1871 DC-DC Booster Converter Case

I wanted a case for this boost converter: https://a.co/d/hFepbhh 

Didn't find one, so I made one.

Very simple, <30 minute print on Bambu X1C printed in PLA.

I used 0.2mm layer height, 10% gyroid infill, 2 walls; but I'm sure any normal settings would also work fine.

M3x6mm (4 or 5mm would work too) screws self thread into the holes to secure it in place.

I will upload a proper picture when I have the chance; the first one printed was immediately used in a project :)