Top cover for CRIVIT fridge 230 V CEK 29 A4

You cannot put anything on the top because it will overheat and stop cooling. This print is a little table on top so air can go around and you can stuck other things on top.

Print legs with default setting.

Print the desk without any bottom or top layers. Switch extrusion width of the infill to 1 mm and use ~10% infill.

There are four 5 mm holes for long bolts (M5/M6) or long screws.

There's also a model for a grid. This is for use inside. Put it at the bottom. If some condensated water was created your things won't by laying in the water.