Tool and Accessory Holder for Voron 2.4 Handle

This model mounts to the voron 2.4 handles which can be found here.

Remove the top middle M3 screw from the handle and add in a 20mm screw in its place to mount this tray to the side of the handle.

The section for holding a piece of 2020 extrusion is there as a hot-tolerant surface for placing freshly-changed nozzles. I change nozzles relatively often and being able to set them on a surface that won't melt is very handy!

I recommend printing the right angle support with high infill, as it's not the sturdiest thing in the world. But it's strong enough for some paper towels.