Discovery Falcon School 3d Printing Elective Challenge

Welcome to the Discovery Charter School 3d printing challenge.

You must successfully slice and print all 3 of the attached models to complete the challenge. Once you've completed this challenge you can find and print your own models

Do these challenges in order.

Prerequisites:

• AppStream / Prusa Slicer link in your email:
• Watched the video from the email with the links

Challenge 1 – Window Frame (from @dezign)

Slice and print this model using the following parameters:

• Layer Height: 0.24mm / Draft Mode
• Infill: 20%

Objective: Learn how to slice and successfully print a model in under 1hr

Challenge 2 – 30min Sphere

Objective: enable build plate adhesion and supports to successfully print the model. Adjust settings to be as close to 30 mins print time as possible.

Challenge 3 – Orientation Model

Objective: Find the orientation that allows the model to be printed without unprintable overhangs,cuts or supports then print the model

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 V2 Neo

Rafts:

Doesn't Matter

Supports: 

Doesn't Matter

Category: Other