Ender 3 alternative Y nema 17 motor mount

This is printable mount for second motor on Y axis on ender 3.
I use 16 teeth pulleys so it is optimized for them. This part is did not meant to be used for thigtening of belt - i use original metal bracket for that with T slot nuts.

I build it with 0.8mm nozzle and 0.35 layer height. My motors pre pretty cool, so I build it from PLA. If you are running hot consider using PLA HT110 or just anneal regular one becouse basically this is kind of load/part whitch PLA excels at…

Orientation longest axis standing (no supports) - there is bit of bad layering in one overhang due to thin wall but nothing serious whitch could force me to build it with smaller nozzle (or redesign) :D

As always - no warranty but best wishes :D