Flsun Q5 FanDuct Remixed_02.01.2024 update

Type A is the version without a barrier.

Type B is the version with a mid-section barrier.

Printing without support

ABS and PETG are recommended, but I printed it with PLA.

----------02.01.2024 update note----------

I've addressed some issues that arose during my one-month usage:

1. I encountered instances where the output material was getting caught due to its low height. To rectify this, I raised the height by an additional 1.5mm.
2. There seemed to be a slight misalignment at the center, so I made some adjustments to realign it properly.
3. To prevent sagging downward, I created a fixed hook.

Printing without support structures.

After printing the fixed hook section, simply remove and refine it.

I edited it to fit the Flsun Q5 swappable duct.