250mm Center Section for 3DPrintDemon's Voron 2.4 Canopy Top Hat Remix!

This is a remix of the 350mm center section of 3DPrintDemon's awesome Canopy Top Hat Remix sized for a 250mm Voron 2.4. 

Print them in ASA or ABS lying flat on the build plate using Voron structural part settings with snug supports for the logo. Like the original, each center section requires two (2) M3x8 screws and two (2) M3 T-Nuts per center section. Four center sections are required to complete the Top Hat. 

The center is sized within tenths of a mm has a really nice, snug fit.  Fitting them will square your corner sections for you if this is not already done. Start with one section, loosen the corners on either side if necessary to perfect fit, tighten everything, rinse and repeat.  

Despite only a sliver of light showing through the seams I used 6mm wide x 3mm tall foam sealing tape to seal them. And like the 350mm original, use 3DPrintDemon's Logo Backs to cover the logo openings. 

Please see the pictures to see how everything is assembled. And thank you 3DPrintDemon for this awesome Canopy Top Hat Remix! My 250mm 2.4 desperately needed the headroom.

This is a remix of the 350mm center section of 3DPrintDemon's awesome Canopy Top Hat Remix sized to fit a 250mm Voron 2.4. The center section has been reduced to 102.2 mm while retaining the center logo and mounting holes.