Large Bird Buddy Suet Ball Holder. No supports needed!

Great design, worked well on my Sparkx i7. Printed in Creality PETG.

sehr gut, stabil und widersteht auch den Angriffen größerer Vögel

Works great for our Bird Buddy!

Printed in leftover PETG that probably should have been dried first, but still came out ok. Attached easily and seems to hold the suet ball securely.

Printed in ABS-GF, 0.20 layer height. Getting that M5 screw into the hole without a power driver is going to be tough. (edited)

Very sturdy. Beautiful design, easy to print.

I like the design of your suet ball so much, i had to make another remix. This time I added a roof to hang this feeder in the trees…

 https://www.printables.com/de/model/896181-birds-fly-in-suet-ball-holder-hanging-type-meisenk

Very good design. I remixed it to be used with a Birdfy bamboo birdfeeder cam. I like how the two halves are screwed together! Great!
 https://www.printables.com/de/model/896164-snap-on-suet-ball-holder-for-birdfy-bamboo-meisenk (edited)

Printed just fine, no big issues. A little bit of stringing but otherwise a solid print. Pieces screwed together perfectly, very well done.

Bought the wrong suet - thought it was the ball type but apparently not 😂 it was cakes. (edited)

The filament was no longer the driest, but the two hemispheres could be printed without any problems.
Shortly after hanging them up, the first guests were already there :-)