Fidgety Spinning Dice - FSD

I was bored, don't shame me too much, it is my first design on Printables. Print both objects and slide the dice into the base. Now just give it a little/big spin.

Print settings:

• 0.1mm layer (it works with 0.2mm but no so smooth)
• 20% infill
• 3 walls
• don't put seam inside the slots

If the dice doesn't spin or fit smoothly , you can push apart the sides of the base with your fingers a little or just reprint the base at 101% scale or the dice at 99% scale. (The clearance is 0.2mm)