Travel Container for Tooth Picks

This listing is my entry in the flash-contest “Summer Camping” . If you download this please help me in this contest my giving this like & perhaps even “make”-picture. /Cheers!

If you print this model, please share pictures.
 

Reasonably sized format if you don't want to carry an entire bulk package of Tooth Picks along your travel as it will fit Approximately 15 to 20 pcs Tooth picks at maximum length of 67mm (~13/5 inches). The tooth picks shown in the picture are 65 mm in length and ø2mm. The inside diameter of the main body is ø10 mm (ø2/5 inches) .
It has a screw cap for safe keeping of picks.
(Measurements on drawing are in millimeters.)

The file consists of the screw cap and main container body
Time to print: 51minutes
Dimensions: L:70,5mm ø16
Used filament: 3,9 grams
This will print fine without any supports at layer height 0,15mm 20% infill. A brim may be needed around the perimeter of the main body or use glue stick (I used glue).

Please kindly take a moment to show your support by giving this a LIKE and downloading it. Thank you so much for your support and I hope you enjoy it!