I liked the basic design by dkacor and tried using it for a while. I wanted to get the storage off of the top of the base extrusion as it seemed to be in the way at times. The only component I used from the original are the tabs to fit into the extrusion. The remaining was re-designed in Tinkercad. I felt comfortable with the amount and type of storage slots and carried them over.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
5%
Filament: Polaroid PLA Silver
Notes:
The supports were small enough I had to use bed adhesion. The fit is snug in the extrusion as designed. The micro sd card slots may be a little snug but I found I preferred that to having them easily knocked out.
Category: 3D Printer AccessoriesThe author remixed this model. Imported from Thingiverse.
Remix to mount on side of printer rather than on top.