Gridfinity Glock Magazine Holder

This magazine holder works with both OEM and Magpul PMAGs, but I have only personally tested it with 15rd glock19-length magazines. With 15rd magazines, the end of the magazine is just barely within the 1x1 gridfinity footprint. 

I have not tested this with magazines greater than 15 rounds such as glock17-length magazines, extended magazines, or drum magazines.

There is very minor wiggle to the magazine fitment, but it will stay upright and magnetized to the gridfinity baseplate even with fully loaded magazines. Magazine rests on its feed lips.

Magnet holes should be a press-fit and are stepped to prevent midair printing. Printable without supports.