Cat Paw Snowboard Stomp Pad

Chair Lifts aren't scary (anymore)! Represent your cat! 

This is a LARGE (around 6") stomp pad with very sharp peaks that'll you skate like nothing else. 
 

Don‘t have a printer? Check out my Etsy Shop or buy it from me directly! 

Tips: 

• Print in PETG, ABS, or even PLA! I sell the pad printed in PETG but my PLA “tests” still hold up day after day. 
• Use a strong, 3M VHB weather resistant tape. I cover the entire paw and it's incredibly strong and cold/water/snow resistant. I use 3M VHB 4905 sourced from Amazon. 
• Clean your board (or at least where you want to apply the pad) and apply at room temperature for the best bond. Wait at least 24hrs if possible before going out. 
• The pad is SHARP. This is by design and it helps to really grip into your boot. Be careful when applying, 

If you want to support me, the best way to do so is buy from my Etsy shop! Use code: PRINTABLES2024CATPAW for a sweet discount! 

Follow me @snowday_blues for really bad snowboarding :)