140mm Fan Rack Mount

This is a mount for your 140mm fans to place in the front or rear of your IT rack with an 80mm spacing from the edge of bolts. Places a 140mm fan bolt edge justified close to center of a standard rack. Can be paired with another on the opposite side to make the full 18 inches of a standard rack and close off 4U worth of space with two fans center justified.

5mm in width to provide rigidity.

4U in space width.

Attempted to create with gap and save material between fan and edge, but lead to structural issues with flex.

20% Infill

Ender 3-V2 used requires GCode to be modified with M211 S0; disable end stops after G28 ; Home all axes - This allows it to take up the full space of the build plate and not run off the edge. ONLY NEEDED IF YOUR PRINTER DOESNT HAVE 235X235 ALREADY SET AND RECOGNIZED ON THE PRINTER

Holes for rack allow bolt pass-through. Holes for fan are sized to standard fan bolt and threads in.