Screwdriver Holder Gladiator Garage Remix from FrankLumien's Design

This is a remix of FrankLumien's Screwdriver holder https://www.thingiverse.com/thing:1322545
I adopted it to be able to use the Gladiator Garage slot wall system. To allow it to match up to the wall I incorporated the keystone mount from don3sch's Gladiator kit
https://www.thingiverse.com/thing:858604

The fit is a bit tight and might require you to do a little sanding. In general I try to get the keystone just started, and then tap it the rest of the way with a ruberhandled screwdriver or mallet.

Print Settings

Printer Brand:

Prusa

Printer:

Doesn't Matter

Supports:

0.20mm

Infill:

Notes:

I would print this with a 3mm brim. There are lots of places on the first layer where things can go bad. I printed this in raptor PLA from makergeeks.

Post-Printing

Making it fit