iPhone MagSafe + Apple Watch Charger

Wanted a nice bedside charger for my iPhone and Apple Watch without spending too much and couldn't find anything that I liked too much so I made my own. Somewhat inspired by the now discontinued MagSafe Duo but kinda reversed where the Apple Watch lays flat while you can stand your phone up horizontally, making use of the new Stand By mode. I recommend using something like the Anker Nano 3 so both chargers can be plugged into one charging brick, and only take one wall outlet. 

Print settings:

Supports: No

Layer Height: .2 mm but it doesn't really matter

Material: PETG but PLA or pretty much anything else should work

Run the wire for the Apple Watch Charger through the hole then press the puck in its place. It should fit pretty hard, so the easiest way to remove it later is to push from the bottom. 

Press the MagSafe charging puck into it's holder then run the cord through its hole as well then you can lay the charger down in its place or stand it up with the slot at the edge of the base.

Finally just fit the wires into the routing grooves on the bottom to help them stay in place. (this is where a little elephants foot might actually help you lol.) 

Everything was designed in OnShape, so if you want to make any changes to a version for yourself, use this link.