Shelf/Tray with Decorative Cover (plus model for TP Link Deco and Battery Backup)

This can be used either as a tray on a desktop or it can be mounted to a wall. Even though it was specifically designed for my own TP Link Deco and battery backup, I have included a version of the tray that doesn't have the inner dividers so you can use it for any other purpose that fits.

The tray can be mounted to a wall by itself but I've included shelf brackets/supports if needed (i.e. if the contents are too heavy without support). The brackets are still relatively thin so don't plan on putting too much weight on them.

Print Instructions

Tray - Print in the original orientation. No supports required, 0.2mm layer height works fine, add a brim to prevent warping. 15% infill or more plus 3 wall loops will be needed if you have a 0.4mm nozzle and don't plan on using the brackets to support it (if mounting it to a wall).

Brackets - Same as the tray but would recommend 3 wall loops if using a 0.4mm nozzle.

Decorative Cover - No supports required, 1 wall loop is fine, 0.2mm layer height prints decently, 10% infill or even lower could work as it's not a structural piece.

Assembly Instructions

Mount to a wall with appropriate fasteners. If using the support brackets it's recommended that these are glued to the tray.

Note: The pictures included differ slightly from the included models because I had designed my own personal version to integrate with my wall plug, so it couldn't sit flush against a wall. The models included here will sit flush against a wall.