RatRig Toolhead Beta2 Beacon Probe RevH Mount

beacon Version i am using at this point in time: v1.0.0-27-g1e7511ca

Check the beacon quick start guide before copying my config and possibly damaging parts.

https://docs.beacon3d.com/quickstart/

Config i am using (USE AT YOUR OWN RISK)

put that in your user overrides and make sure you have no [Probe] section ANYWHERE

[include RatOS/z-probe/beacon.cfg]

[beacon]
y_offset: 20.676
speed: 5.

[resonance_tester]
accel_chip: beacon
probe_points: 150, 150, 20

[stepper_z]
endstop_pin: probe:z_virtual_endstop # use beacon as virtual endstop
homing_retract_dist: 0 # beacon needs this to be set to 0
homing_speed: 5

[z_tilt]
z_positions:
0,0
150,300
300,0

points:
60,30
150,230
240,30


[bed_mesh]
horizontal_move_z: 5
mesh_min: 35,30
mesh_max:265,270
probe_count: 15,15
fade_start: 1.0
fade_end: 10.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2
speed: 250

Beacon RevH Support