https://mods.vorondesign.com/detail/FB646KO2cokFqN0D6vl0A – V0.2 Stealth Skirts by Maverick
This is a remix adding two keystones to the rear of the sleek looking Stealth Skirts mod for the Voron v0. Easy access to USB, Ethernet, or HDMI from your Raspberry Pi or Pi equivalent.
I was worried about Z motor clearance on the center placement, so I've added an offset mount as well. Examples printed with Anycubic ASA filament on a Neptune 3 Plus. Filament color swap at 2.20mm.
I used pass through female - female keystones similar to these:
RJ45 https://www.amazon.com/gp/product/B005E2Y4O2/
USB 3.0 https://www.amazon.com/dp/B07Z94HYFG/
HDMI https://www.amazon.com/dp/B07WYQ33M4/
Short male - male cables required to connect to your MCU.
The author remixed this model.
Reduced the gap between the keystones and overall width from the V0 rear_skirt 2 Keystone.stl file on the Voron v0 Rear Skirt Keystone printables page by @greecher. Removed the intersecting accent mesh and merged with the Rear_Skirt_x1.stl file from the V0.2 Stealth Skirts page on mods.vorondesign by Maverick.