Sovol SV04 Filament Dryer Mount

This fully printed model provides a mounting location for the Sovol SH01 filament dryer on top of the SV04.

The base and horizontal truss are exposed to the heat of the dryer so should be printed in PETG, ABS, ASA or something with equivalent or higher heat resistance. All other parts can be printed in PLA if desired. The fit between parts is firm so a little force may be required during assembly. Recommend printing the truss members with 100% infill, which isn’t a lot of extra material given the small section size  

Some additional notes below:

• Clips have been provided that insert into the upright truss' that keep the dryer power supply cable out of the way of the print bed, take care to roll the cable into clip to prevent breaking the small hook.
• Take care to assemble the upper and lower uprights sections together with the correct orientation. 
• The base flexes slightly under the weight of the dryer, however, this is ultimately not of any consequence. 
• You will need 2 x lower and upper uprights and probably min. 2 x cable clips.

To get access to the dryer screen when mounted it is best to relocate the filament sensors from the factory location, the brackets at the following link will do the job - https://www.printables.com/model/709171-sovol-sv04-filament-sensor-brackets

Let me know how you go, I would love some feedback!