this model is a remix of a 92fs magazine that i filled in and then spliced it with a 10/22 hanger from the awesome makes above. this is a very crude model and i may in the future make it better. i will be testing the durability of it myself with a rifle on the wall and hope that it will work. this is printed on a bambu labs printer with pet-g and it may need a tiny bit of supports on the side. also due to the license from another user this is what it shows up as. i dont care if it remixed or used or anything good luck to all and keep printing you beautys.
this model works actually very well. there is a bit of squish on the side to accommodate any tight mag wells and seems quite rigid. i am no engineer or person who went to school for this, just a guy who loves guns and has a 3d printer. I had a comment about the top hole not being there. my bambu labs will not let me mesh boolean a hole into the top part so anyone that prints this just be aware that if you can put your own negative into the top screw hole that would help with the installation of the top screw hole. apologies for the inconvenience, but this is as much as i can do to help so far. Cheers to my bada$$ community.
The author remixed this model.
used a magazine from a model 92 and a wall hanger from a 10/22 model spliced together. i had a comment about the top hole not being there. my bambu labs will not let me mesh boolean a hole into the top part so anyone that prints this just be aware that if you can put your own negative into the top screw hole that would help with the installation of the top hole. apologies for the inconvenience, but this is as much as i can do to help so far.