Fan Duct for Tukkari TF Acrylic Enclosure - 120mm Fan to 100mm Pipe adaptor

Materials and specifications:

• PETG or ASA/ABS reccomended;
• 0,2 layer height;
• 5 perimeters/shells;
• 120mm fan (personally I used this https://amzn.eu/d/gUrk2gO plugged into an octopi);
• 4 M4x40 hex screws;

Assembly 

Mount a 120 mm fan sandwiched between the fan duct and the hepa filter included with the Tukkari TF enclosure in a pull configuration, be sure the air is drawn out and not pushed inside the enclosure.

Test the system by lighting and blowing out a small candle near the fan.

You can either print the fan and duct already as one or separately.