Whoop Canopies [Runcam Nano 3, Foxeer Razer Pico, LDARC 199c V2.1]

The Runcam Nano 3 bracket is the same as the one used with the Mobula Canopy which attaches to the back of the Nano's backside and is attached to the canopy via 2 screws. Normally, you would print this in a rigid filament such as PLA.

The Foxeer Razer Pico adaptor is also meant to be used with the Mobula Canopy. It clips onto the camera's lens as I did not want it to be a permanent solution. This would also be printed in PLA or hard TPU.

The 199c camera canopy is a lightweight simple canopy that has a fixed camera angle of 23 degrees. I found that canopies similar to this tend to be 30 degrees or more which was too high for me. This should be printed in TPU and I can get it around 0.8g.

All the STLs have their corresponding .f3d files here so feel free to remix this to fit your needs or tolerances of your printer.