Horizontal iPhone Magsafe Stand - 20mm shorter version

Printed with Prusament Jet Black PETG. This model is a little tricky to print without supports but I was able to get fairly good results by lowering the nozzle temperature and increasing the extrusion width of outside perimeters.

The iPhone-only version of this magsafe charging stand does not need to be as tall as the other stands since there is no secondary charger below the phone. I made the stand 20mm shorter so it more easily fits under my monitor and is less likely to tip over. I also enlarged the opening for the USB cable slightly so that the cable can be more easily routed through the bottom of the stand.