Vases and flower pots waterproof

Hi I made 9 vases that are printed in vase mode, and 11 flower pots that are printed in normal mode.

There is always one full one - for vase mode and one  with a hole - for normal mode (two for square flower pots with square hole and round hole), both can be used as a pot, but the difference is that the ones with a hole are thicker so they are more durable and don't need to be handled as carefully as the ones for vase mode

It can be used as vase, decoration, flower pot, basket for pens and pencils and more.

I cut some models to be shorter to save some filament.  
You can make the models as big or small as you like.

I modeled them in Fusion 360 and printed them on MK4 and they are waterproof for me, but I can't promise they will be waterproof for you as you may have a different printer.
 

Models specified for vase mode are full.

Vase mode you can find in every slicer, I use Prusa slicer and you can find it here.

PRINT SETTINGS

Vase mode- check the box to enable vase mode and set the layer height to 0.15 mm, I used it and it works for me, but it can be printed with any layer height. I printed it in PLA, but you can print it in other materials like PETG, ABS, ASA and others. Print it in any color you like. No supports

Normal mode- Use 0.20mm layer hight infill 15%, infill patern use grid, 2 perimeters and you dont need any supports.

I hope it printed well and works as it should. If you like my models I would be very happy if you would share your print and you can give a heart too. Thank you.