Saturn 2 PTC Heater

My printer enclosure required heating due to the low temperatures in my workshop. The published equipment did not meet my requirements and I have a different thermostat in use for temperature control.

The holders and model carriers available here are all suitable for 12V/24V systems with 100W power. My PTC element has more power and melts the printed housing after a few minutes in the side areas where there is not much airflow.
That's why I developed a model that accommodates the original housing.

Please also check the dedicated control unit designed for this heater:

DIY Heating System for SLA 3D Printers

Matt's longer bracket has remained unchanged, but the frame for my 220V 300W fan heater is not sufficient and is melting, so I have redesigned the housing to accommodate my fan heater in the original. In continuous operation there have been no malfunctions so far, I control the temperature via the STC-3008. Take a look at my models.