Revo Voron Adapter - Rat Rig Toolhead V1.0 BETA V2

This is a adapter to mount a Revo Voron on the Rat Rig Toolhead V1.0 BETA V2.

You need to print a new toolhead front.

I tested the mounting, but did not print with it yet!

Additional hardware needed:

• 4x M3x6
• PTFE Tube 30.8mm

Assembly steps:

1. Test the fitting of the PTFE tube. In case it doesn't fit, drill out the hole with a 4mm drill.
2. Test the fitting of the M2.5 screws in the plastic adapter. Tap the holes with an M2.5 tap or widen with a 2mm drill if they don't fit.
3. Mount the Revo Voron heatsink with 4x M3x6 to the printed adapter
4. Mount the Revo Voron heatsink and adapter to the aluminium plate as you would with the Rapido Extruder