Remix Webcam Stand for SOVOL and similar 3D printers with high build plates
Webcam stand was remixed to better view my SOVOL 3D Printers which tend to sit a bit higher,
1
23
0
188
updated
January 10, 2024
Description
PDFI needed to modify this Webcam Stand as it was too low to view my print bed on my SOVOL SV01 Pro. I extended the entire size to 92mm and thinned the base to 6mm. The top was slightly shaved to 3.5mm. The screw mentioned in the original Model Post is a must!
Layer height .2mm
The infill was done at 10%
No supports
Use with this screw.
https://www.thingiverse.com/thing:578514
On the screw, I recommend printing with a wide brim for build plate adhesion.
If you download and print, please be sure to Like this model, and post your makes!
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
I extended the entire size to 92mm and thinned the base to 6mm. The top was slightly shaved to 3.5mm.