Bowden Bracket for EIBOS Cyclopes

This bracket is designed to be fastened to the base of the EIBOS Cyclopes filament dryer and replaces the two rear ports on the lid with two on the base, making filament changes easier and less fussy as you should no longer need to remove the filament rolls with the lid.

You will need to cut two slots in the lid and remove the old ports to accommodate the bracket as well as 3x plastic-fasteners to affix it to the base.

Installation:

1. Remove rubber grommets from the two rear ports on the lid and align bracket ports with lid ports.
2. Trace edges of the two most prominent steps in the bracket, then cut out material from the lid so that bracket can fit inside the lid as shown in photo.

1. Mark a center line at the rear of the base.
2. Align bracket along the back and mark three holes.
3. Drill holes in base and fasten bracket.
4. Insert grommets into bracket ports.