Caulk Tube Cap

It just works.

Absolutely amazing, great model!

Thanks for the design! Quick and simple print

Cool idea, I'll have to scale it down for new nozzles or try an o-ring.

Nice design, and it's handy when you lose the original cap for the caulking tube. Fits well and provides a good enough seal.

works👍

I printed the version with plug - as indicated, you'll have to be careful removing the inside brim as the plug is quite delicate and easy to break

Printed in TPU. Removing the internal brim was impossible so I just cut it off.

its like a little cone that tells the caulk to STOP

I used TPU to print the caps with the sprout, so far it works but the cap is a bit too wide for the long sprouts that came with my silicon tubes. TPU might be a good idea because of the strong layer adhesion and stretch, wich makes it easier to pull out without breaking.

Not much to it, but it works exactly as it should. I didn't do a brim on my Elegoo CC for the cap with a plug and there wasn't any issue.

Handy! Needed a cap for this expensive goo, a bit of fiddling with ratio and voila!!
Thank you!! (edited)