HSW Empty Insert - Rotated

Take a look at the pictures to see what I've created (upper insert) compared to the standard (lower insert). I can't speak to the structural strength (or weakness) of my model - add comments if you have some.

If you have settings that have already been working with the HSW system, then you should be good to go. If not, what I've been doing is:

• Print External Perimeters First
• Layer Height: 0.2mm
• Infill: 0%

The face looks pretty ugly (I've been printing with the face down as the first layer) but the exposed face is pretty small and once I add an a specific insert it's not noticeable at all.

Empty insert rotated 30 degrees in for use in a setup where the honeycomb is rotated 30 or 90 degrees.