Get Free Shipping & Prusaments with the Prusa XL Summer Deal!

Hygrometer for Filament Dryer Esun Ebox Lite (rear mount)

Hygrometer mounting plate to mount the hygrometer holder at the rear of an Esun Ebox Lite
13
54
0
549
updated January 7, 2024

Description

PDF

Some small changes to the great design of @vivamus3d https://www.printables.com/model/274551-hygrometer-for-filament-dryers-sunlu-s1-and-esun-e/files, allowing the mounting plate to be put at the back (where the lid hinge is) of an Esun Ebox Lite. Lift up the metal plate slightly by hand and slip it in - make sure the cutout in the middle is snug arount the ridges for the hinge. 

Also removed more material at the sides, because my large spools was otherwise dragging on it…. This is bad for rigidity etc - but once in place it isn't under much stress. 

 

Any build instructions for the original go for this one as well, and should retain full compatibility with all the hygrometer holders that slip into this mounting plate, but only tested with the round model. 

 

All kudos to @vivamus3d! 

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

  • cutout in the middle to accommodate the ridges of the rear hinge
  • removed more material from the sides, to avoid large spools dragging

License