Cosmetic Face Pads Holder
Description
PDFThis idea came about thanks to a suggestion from a work colleague who needed a face pads holder/ dispenser which was easily relocateable but less likely to topple over or be knocked off the dressing table.
The 5mm x 60mm Dia steel disc weight in the lower cavity can be found on eBay:
https://www.ebay.co.uk/itm/302638393122
Secure it in place with a line of CA glue around the edge and seal it in the cavity with the lower cover, again using a thin bead of CA glue around the inner edge/ step on the base cover.
It stands a little shy of 120mm high and has a diameter of 70mm.
Assembly is quite self-explanatory - An alternative weight can be used, like a small disc of lead roof flashing should be OK, as this will still be sealed inside the base.
The whole item is otherwise quite light, so some sort of anti-topple method is useful (noone really wants their hygiene items to end up on the floor!).
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
No
Supports:
Doesn't Matter
0.2mm
Infill:
15%
Filament:
Generic PLA PLA Colour to suit.
Notes:
On the Prusa MK3, with the PRusa Slicer 2.3.1 and with suports selected for 'everywhere', it will still manage to print the lower cavity without using supports underneath - just allow it to 'Detect Bridging Parameters' and it'll work.
Use brims just in case, but this may not be necessary.
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
