MiniZ Ford Mustang 1967/68 fastback with more wheel clearance

This is a remix of the MiniZ Ford mustang 1967/68 fastback (sportroof) body. I cut out additional clearance for the front and rear wheels in order to allow better steering and suspension travel specifically on the Fully Printed 1:28 Car Chassis (MINI-Z compatible). It should theoretically also be compatible with a normal Mini-Z chassis with a 90mm wheel base.

I also remixed the screw holes on the front clip for more durability, as I was finding that they would break at the slightest crash. It should still accommodate M2 screws in the same position as the wider holes in the original clip.

I have also included a body with even more wheel clearance, at the cost of looking a little silly and some slightly lowered detail on the overall model.

I cut out additional front and rear wheel clearance from the original model in order to allow better steering and suspension travel. I also remixed the front clip to be sturdier around the screw holes, as it was breaking every time I lightly crashed it.