Adafruit Braincraft Hat Cover for Pi 5 Official Case

Use a piece of 1.75 mm filament to hold the hinge together.

Printed without supports.

Products used:

Pi 5

Active Cooler

Pi 5 Case

Braincraft Hat

Pi Camera Module 3 (you will have to make the hole bigger in tinkercad if using Pi Camera Module 3 Wide Angle Lens)

Ribbon Cable (I'm using this version because it seems thinner than the new version here)

You will also need 8 M2x4 screws for the camera and 4 M2.5x6 screws and 4 M2.5 nuts for the base plate.

Insert the ribbon cable into the pi, then snake it through the braincraft hat and attach the hat to the pi. Next, snake the ribbon cable under both support brackets so it's flat against the case. Then snake it over the top bracket, under the bottom bracket, and then into the camera.

I used the base they created for the back of the camera case to create a base that sits on top hat.