Sram GXP pressfit install tool

This is an old design that  I imported from my prints on Thingiverse.

This is a remix from the parts needed to install a bottom bracked from https://www.thingiverse.com/thing:2303747

I made this to install a Sram GXP pressfit bottom bracket. I will make some tools to remove the bottom bracket when I need them or remove the crank for maintainance.

The drive and non drive side bushings are marked with "drive" and "non drive" on the underside.

To install the bottom bracket see the instuctions here: https://www.thingiverse.com/thing:2303747

Print Settings

Printer:

Colido/Printrite DIY

Rafts: 

Doesn't Matter

Supports:

No

Resolution: 

0.2

Infill:

40%

Notes: 

Maybe it will work with less infill. But the old bottom bracket was a very tight fit so I wanted to make sure it was strong enough.

Printed in PLA.

Category: Sport & Outdoors