(Watering Can)³

Minimalistic, cubic watering can with hidden water intake in the bottom.

To fill it:

• Turn it around
• Fill till it overvlows through the outlet
• Wait till no water is leaking from the outlet
•  Then quickliy turn it back in upside. (Best is to turn it over the corners with not intake or outlet.)

Be aware, it will always loose some water in this process.

After this the watering can is save to use (except you tilt it backwards, then you will get wet).

Can be printed witout support, no ovehang is greater than 45°

(Don't get confused by the 3D preview on printables, it seems, that the water intake in the bottom is not renderd, but it is there … i promis)