Made to for my rx7 dash. Printed in abs, face down, to get the texture of the PEI bed that almost matches OE Mazda texture. Included STL and F3d files for modification. There is also a groove in the bottom to allow for a strand of 1.75 TPU filament to stop rattles if you have one. I thought I would but mine does not. Fits snug with no rattles at all, and sits flush with the dash. Printed at .2 layer height on eSun abs. No supports, I did use a brim to help reduce warping, printed at 100mm/sec on CR10spro with sonic pad. 80c initial layer bed temp and 85 after that, with nozzle temp at 240, .5 nozzle.
The author marked this model as their own original creation.