Creality Falcon 2 12mm Laser Crosshair Bracket

This mount is to add a 12mm laser crosshair for the Creality Falcon 2 22/40w laser engraver/cutter. 

I removed the original cable from the laser module by opening the module. I took the cheapest USB-C cable and cut it to about 10 cm, the cable only had 2 cores, the end of which I cleaned and soldered to the place of the original cable.

Extra hardware: 6mm screw to replace the 4mm from the laser module, (the screw is part of the Falcon2 package) 

Print Settings:

• 0.2mm Layer
• material: PLA (or any)
• Filament used(g): 2.7g
• Filament used(m): 0.91m
• Est Cost (PLA): $0.08(eur)
• Print time: ~8min

This version is for 12mm laser modul.