USB Cable Hanging Mount

A basic USB holding mount that is designed to slide on to edges roughly 20mm thick.
it can work with thinner edges if you use some form of shim.

There are 10 holes, so you can either hang 10 different cables or the ends of 5 cables.
There is also enough room on the top if you wish to label the cables.

There is also a notch on the front incase you wish to secure the cables with a rubber band or similar as shown in one of the photos.

This was Version 2 of my design. On my original attempt the holes were a bit too shallow, so I made them a bit deeper. I also added the notch.