Raised Floor Segment for Sterilite Blue 54Qt Gasket Dry Box

I wanted to spread my silica gel desiccant beads evenly on the bottom of my dry box for maximum surface area, but hated crunching my filament spools directly into it and having little orange beads get pulled out from time to time. This is a raised floor segment made specifically for the Sterilite Blue 54Qt Gasket Dry Box, though it may fit other containers with similar measurements. 

Each segment will hold 2 filament spools, and supports spools of varying widths. 12mm clearance from the bottom of the floor plate to the bottom of the feet. The extra holes are for weight/filament waste reduction. 

Printing Notes:

• No supports needed
• 4x need to be printed to fill out the bottom of the Sterilite 54qt container
• ~60g filament needed and ~2 hours per segment depending on settings
• Mating holes fit M3 heat set inserts and M3x12mm screws