Replacement/Ersatz Brogrund Ikea

Hi i did a new design of the ikea Brogrund because mine broke into two pieces while cleaning. And since i only needed a single side i designed it to be printed on a prusa mini bedsize. 

You need the mounting piece of the original Brogrund to install it!

I recommend to print it with PETG. But you can print it in PLA if you seal the Printed surfaces with clearcoat. 
 

The part has been designed for pressfit. And Print it with organic support. You need Around 90~100g filament depends on what supports you use and how much infill.

0.2 layerheight, 3 Perimeter, 4 Top and bottom layers, 15% Infill, Organic Supports, and it does not matter on which side you print, the filament amount is almost the same.

Have fun printing.