Elevated Tablet Stand

My septuagenarian mother loves watching Netflix on her tablet. She would rather use her tablet than a Smart TV. However she complained about neck ache when watching it while the tablet is on the table. So I made this stand for her so that the tablet can be set at eye level for a more ergonomic experience.

The design requires some non 3D printed parts which are:

• 40mm PVC pipe that determines the maximum height of the stand
• 4x M5x40 Hex Bolt plus nut
• 4x M3x10 Screws

All parts are ready oriented for printing without the need of supports and can be printed using PLA.

Suggested settings:

• 4 walls
• 6 top and bottom layers
• cubic infill at 30%
• 0.2 layer height