Horizontal Phone Holder

I designed this horizontal mobile phone holder to fit in the center console of my 2017 Honda Civic. I printed it in MakerGeeks MakerFlex for the rubbery, flexible (but firm) feel. You can vary the infill to make it more or less flexible. It is shown with an iPhone 6s.

Print instructions

Printer Brand: Prusa

Printer: [Prusa Mk2]

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 25%

Post-Printing

The flexible filaments seem to have more stringing than I see with regular PLA, but a few minutes with an side cutter will clean it up.

How I Designed This

Designed in Fusion 360